logo
 
 

Bilge Pump Thru Hulls

As you can see by my previous post, I have a rather large amount of bilge pumps going into my boat, 10 bilge, 6 AC, and 2 sumps. That means a lot of....

 
 

Thoughts On Leasing Out My Trawler For Loopers

Hi all newbie on the board. I have an idea of possibly doing an annual lease on my recently purchased 2004 GH-37 to experienced individuals...

 
 

Hose Barb Fitting

The upper groove ring was scored by a hose pick. Is it better to replace it or does it still seal?

 
 

Rear View Camera

Our Helmsman 38 has zero visibility aft. The nav system has a rearview camera, but it requires that the screen show just the view to the rear, so...

 
 

Bow Thruster

I have a '98 350 with a Bow-Power belt drive thruster. Is anyone familiar with this unit ???, was it original equipment ??? ..... it is next to useles...

 
 

Yanmar Elbows - Do These Need Replacing?

I have twin Yanmar 4LHA-STP engines on a Mainship I bought in 2018. The previous owner said the elbows were recently replaced but didn't have the exa...

 
 

FL 120 Injection Pump Fill Level Stripped

Going through the engine, changing fluids, hoses, coolers, and heat exchangers. While checking the fluid level in the injection pump before draining, ...

 
 

Unequal Oil Pressure Readings

Twin Cummins 6bta 330hp. At 1000rpm starboard oil pressure is reported by analog gauge 65 lbs, port reported at 30+/-. Same report at both helm...

 
 

Detroit 671 Rebuild, Wrist Pin Cover Won't Hold Vacuum

HI, I am helping a friend rebuild his Detroit 671's. We are assembling the new pistons, rings, liner etc... As we pound in the wrist pin covers...

 
 

Lehman 135 Specialty Tool

Have a friend with a Ford Lehman 135 that probably needs a special tool. On the injector pump, there are fittings that are screwed into the injector.....

 
 

Transom Steps

I am looking for recommendations on replacing the two transom steps on my Mainship. The boat is a DC40 and it has two separate steps on the transom...

 
 

Leaking Fuel Port Fitting On Deck; Best Method For Resealing?

Hi All, I have a small leak, leaking into the boat from the deck-mounted fuel filler fitting. I have not had to reseal these prior but I have a few...

 
 

Holding Tank Deck Pumpout Location

We are considering adding another waste holding tank and are curious if there is a rhumb-of-thumb or limit on the maximum distance between the tank an...

 
 

Essentially New Mastervolt Combimaster 12v/3000w/160a And Battleborn Batteries

Just purchased a new trailer and it has a Mastervolt Combimaster 12V/3000w/160a (and smart remote) in it with 4 heated 100ah Battleborn Batteries as.....

 
 

To view this email as a web page, click here


To view past issues of this newsletter, click here


Trawler Forum is owned & operated by Social Knowledge, LLC
2600 E Southlake Blvd Suite 120-361 Southlake, Texas 76092

Click here to view our privacy policy.

Questions or Comments? Contact support at support@socialknowledge.com.

Add newsletter@trawlerforum.com to your address book to ensure future emails arrive.

Join us on Facebook Join us on Facebook