I've done about half of the Great Loop by bringing my Lagoon43PC from Vermont to Tampa when we relocated to Florida. I'd like to complete the Loop by....
|
|
|
I was motivated to ask this question after reading a good article about the last manned lighthouse in the U.S., although it could be related to the...
|
|
|
I will be starting the gas to diesel repower of my '88 44cmy in December. Part of the job is to get new aluminum tanks built. Has...
|
|
|
Hello, the AC install has begun on the boat wondering what material people have used for raw water manifolds and if one was required for your A/C unit...
|
|
|
Hi All, A big hello, and as a newbie, this is my first post asking the community for some wisdom. My wife and I sold our cruiser and are now...
|
|
|
I have enjoyed a long time reading posts on here via my husband and finally became a member myself. ...
|
|
|
Is anybody using it? Planning to buy 300+ ft of 3/8” G4. I’ll get a sample from the dealer first to check on the gypsy. I see better prices on it vs....
|
|
|
My inverter charger 100 amp does not have a program for charging lithium-ion batteries. If I hook up the charger to a programmable solar controller...
|
|
|
Hi all, I think I've mentioned in various postings that, very slowly over the years, I've been poking at getting a touch panel made specifically for....
|
|
|
Have a Deere 6404 diesel with no turbo. The existing exhaust exits the engine manifold with 2.25-inch Inside Diameter pipe into riser and mixing elbo...
|
|
|
I had to make a new base to hold the rear bottom of my eisenglass because 40 yrs was just too much for the doug fir from the factory. In order to...
|
|
|
Hot water pressure is fine in the galley and showers. Two heads have the attached Moen fixtures and hot water literally trickles out. This has...
|
|
|
Hello all! I am working to come up with a plan for the upcoming season, mid-December to mid-May, for cruising the Bahamas in our bluewater trawler...
|
|
|
|
