Hello all We have used our boat 600 or so days in the past three years. I rebuilt the Jabsco Quietflush toilets last Fall. They were gross...
|
|
|
It seems most used boat buyers (I'm guessing around 90%) rename their boat. I am likely in the minority and kept our boat's name--it had a really...
|
|
|
On our multi-state trip home disaster struck. My fault, I got stuck in low tide not watching what I was doing. Boat listed pretty good to starboard......
|
|
|
I'm trying to remove the aftercooler from my Cummins QSB 5.9 and the four 15mm bolts that attach it to the engine are TIGHT. I will try a breaker bar....
|
|
|
I have a 1984 Nordic tug 26 sitting in my driveway on a trailer my question is can I modify it without affecting resale I spent a fair amount of my...
|
|
|
I recently purchased a Helmsman 38E, and the previous owner had swapped out the original 45# bruce anchor for a Mantus M1 65 pounder, along with a...
|
|
|
I just got done upgrading to the new KVH V30 mini VSAT satellite communications system. I found the installation to be very easy, and...
|
|
|
Hello! I am hailing from the beautiful Palouse region of Eastern Washington and Northern Idaho, not far from Hells Canyon where the Snake and...
|
|
|
Having an issue with our two VHF radios. We have two standard horizon GX6000 radios. When we transmit on some channels on one radio we will clicks or....
|
|
|
Doing some detective work on my buddy's CHB 34. The primary Racor filter has some visible "sludge" in an internal part of the housing inside the...
|
|
|
The raw water pump runs and the flush pump runs, but the bowl does not empty. None of the bowl contents appear clog-worthy. The 30 gallon holding...
|
|
|
I am installing a new vent hose on my holding tank. Besides hose clamps, is there a recommended putty or product to use to help seal around the...
|
|
|
Hello everyone, I recently acquired a 1983 Californian 38 Sedan. On the lower helm dash, next to each ignition key is a red light labelled "SOL"....
|
|
|
It's been a little while since I read horror stories about the Dockwa way to reserve a slip. We are on the inland rivers, on our Loop, and a...
|
|
|
I started in on the new to us Egg Harbor. The old Varnish was flaking off after years of neglect. I stripped it with a scraper, heat gun. Then hit....
|
|
|
Currently in a haul out to fix some serious over zinc damage around the shaft log and am stuck on how to move on from here. There is an original ...
|
|
|
Looking at inventory and boats to replace my Navigator. Looking for one that is super easy to maneuver, bow and stern thrusters. Small enough to get.....
|
|
|
|
