I have a new-to-me Marine Trader I just bought. The previous owner died about 18 months ago, so there's not much info about the systems. There were....
|
|
|
I'm planning and budgeting for the inevitable replacement of my exhaust manifolds and elbows, as the boat is over 20 years old - nothing lasts...
|
|
|
Hi, and apologies for annoying you again so quickly. Though there may be a few of these as I move through the purchase process. The Trawler I am...
|
|
|
Hi all, I am replumbing my CHB 42' trawler. I am going to use a Grundfos Scala 2 AC pump and pex with a manifold. I am attaching a diagram. ...
|
|
|
The model number is Model is 8-E32OZD This generator will be the death of me. So I started it to warm it up for a simple oil change. ...
|
|
|
Heading down Hood Canal for the first time we stopped off in Pleasant Harbor and were astonished to find the water temperature sensor (three feet...
|
|
|
I was changing out the lift pump on my engine with a spare that was on the boat when purchased. The pump I removed has a different lever to the...
|
|
|
Trying to figure out the black hydraulic holding tank connected to the autopilot pump. It seems like an overflow tank but it's at the lowest point of....
|
|
|
My Lehman 135 lowest idle is 750 rpm whereas it used to be around 450 rpm. Not sure if recent injector servicing would cause this or if I knocked the....
|
|
|
I have an NMEA2000 backbone installed and use a permanently installed navigation computer (Windows 11) with two 24" touchscreens for TimeZero in the.....
|
|
|
To most, this probably is a simple question but I want to do the right thing. I have to replace my battery selector switch in a 1979 Albin 33 as part....
|
|
|
Just bought a boat. Question on the 120 Leyman. Can I start the engine with the water pump impeller not in for 30 seconds? I'm changing the filters...
|
|
|
I am gonna change out the through hull for the engine cooling water. It seems to have a standard through the hull. My question is, should I put a stan...
|
|
|
|
